TFW offers swing check valve in DN 50-600 with bar and also weight, springtime and also bar or with shut bushings. TFW swing check valves feature very simple accessibility to maintenance and also can be installed in both vertical and horisontal settings.

What is a swing check valve?

A swing check valve is mounted with a disc that swings on a joint or shaft. The disc swings off the seat to permit forward flow and also when the circulation is stopped, the disc swings back onto the seat to block reverse circulation. The weight of the return and the disc flow has an effect on the shut-off qualities of the shutoff.

Swing check shutoffs with lever and weight or lever and springtime

Commonly a lever as well as weight or a lever as well as spring are installed to attain optimum efficiency. Swing check valves with bar as well as weight are appropriate for installments with an enhanced risk of water hammer at common velocities. Swing check valves with bar as well as exterior springtime appropriate for high pressure, inadequate back pressure as well as high circulation speeds.

A crucial thing to be familiar with when mounting a swing check valve is, that it is not entirely maintenance totally free given that the disc needs to be cleansed occasionally. Additionally, a lever is typically installed to allow visual check. Turn check valves are often set up where workers is present..

Benefits of TFW swing check Valve shutoffs.

TFW swing check shutoffs are developed with concentrate on easy accessibility to maintenance. By unscrewing a few bolts the hood setting up including joint and disc can be gotten rid of from the body, and also maintenance can be performed..

Special disc design.

The light-weight disc of EPDM rubber with lip securing as well as steel insert calls for a minimum of pressure to open and shut the shutoff. The disc is placed in a nylon bushing, which enables it to relocate a little both horisontally and also up and down to close totally limited additionally in case of minor pollutants in the seat. The seat is put in a 20 ° angle providing tightness also at low backpressure. The joint is made from acid-resistant stainless-steel and is securely tightened around the shaft with screws to eliminate play and also hence to guarantee sturdiness. Where minimal space is offered, the hinge can be positioned backwards setting.

Avoid water hammer.

When installed with lever and also weight, the swing check shutoffs in little measurements provide the opportunity of priming by moving the bar by hand. The weight is flexible on the lever to accomplish a soft closing against the seat along with an optimum closing rate to prevent water hammer. A guard covering the bar and weight is readily available as an additional safety and security, as it gets rid of the risk of injuries. The guard is readily available with limitation switches for remote surveillance.

TFW swing check valves are available in resilient seated layout in DN 50-300 and also in steel seated design in DN 350-600.

Highlight summary for TFW swing check valves.

Bonnet/disc layout offers very easy access to maintenance.

Disc with steel insert is fully vulcanized with EPDM rubber (approximately DN 300) guaranteeing optimum sealing capability.

Lip sealing on the disc makes certain rigidity.

Light-weight disc requires a minimum of force to shut the shutoff and open up.

The disc has the ability to move a little both horisontally as well as up and down to shut entirely limited.

Joint tightened up around the shaft with screws to eliminate play and therefore make certain longevity.

Full bore makes certain low head loss.

Ductile iron with epoxy finish in compliance with hullabaloo 3476 component 1 as well as EN 14901.

Please contact us if you need help and inquiries.